Pci/Plug And Play Setup Page - ECS Motherboard User Manual

PCI / Plug and Play Setup Page
This page sets up some parameters for devices installed on the
PCI bus and those utilizing the system plug and play capability.
CMOS SETUP UTILITY – Copyright (C) 1985-2003, American Megatrends, Inc.
Primary Graphics Adapter
Allocate IRQ to PCI VGA
PCI IDE BusMaster
Primary Graphics Adapter
This item indicates if the primary graphics adapter uses the PCI
or the AGP bus. The default PCI setting still lets the onboard
display work and allows the use of a second display card
installed in an AGP slot.
Allocate IRQ to PCI VGA
If this item is enabled, an IRQ will be assigned to the PCI VGA
graphics system. You set this value to No to free up an IRQ.
PCI IDE BusMaster
This item enables or disables the DMA under DOS mode. We
recommend you to leave this item at the default value.
Chapter 3: BIOS Setup Utility
PCI / Plug and Play Setup
PCI
Yes
Select which
Disabled
graphics controller
to use as the
primary boot
device.
33
Help Item