Screen 3: Retransmit; Screen 4: Time & Date - DAVIS Vantage Pro Console Manual

Using the Console

Screen 3: Retransmit

The console/receiver can re-transmit data to other console/receivers, or to the
Davis Weather Echo and Weather Echo Plus.
Note: This feature is not available in the cabled Vantage Pro station.
Setup screen 3 lets you switch the retransmit feature on or off. Use the "+" or "-"
arrow key to choose "Retransmit On" or "Retransmit Off". Use the STATION
key to choose and assign a transmission ID to the console/receiver. Note that
only IDs you're not already using will appear.
Press and release the DONE key to move to screen 4.
Screen 4: Time & Date
On first power-up, the time and date are set to the factory default January 1,
2000, 12:00 midnight.
• Enter Time
Press and release 2ND, then UNITS if you wish to change from the 12- to
the 24-hour clock, then use the "+" or "-" key to change the hour. Press the
RIGHT arrow key to move to the minutes field, then use "+" or "-" key to
change the minutes.
• Enter Date
Press and release 2ND, then UNITS if you wish to change from MM/DD to
DD.MM or vice versa. Use "+" or "-" to change the first field. Continue
pressing the RIGHT arrow key to move to the next field, and use "+" or "-"
to change the number shown in that field. Press the LEFT arrow key to go
back to the previous field.
When you're done, press and release the DONE key to move to screen 5.
Page 22
2
am
Vantage Pro Console Manual