Flowchart; Flowchart For Connection And Settings - Mitsubishi Electric DX-TL5000U Installer Manual

Flowchart

Flowchart for connection and settings

This is a flowchart of the example operation:
Making connections of the terminal on the rear panel
initial settings Making an alarm recording with timer recording
Playback the recorded data
Connections
• Connections for camera, monitor, and sensor.
See " Connecting to CCTV camera, monitor,
and sensor" on page 17.
• Connection for the alarm recording.
See " Alarm recording connection" on page
18 and " Rear view" on pages 15, 16.
Boot-up the unit
When not executing Setup Wizard:
See " Setup Wizard" on pages 30, 31.
Only when the unit is turned on for the first time, the
<Setup Wizard> screen is displayed automatically. It
is not displayed next time.
• Set the present time and HDD settings in each menu
manually. (" Time/Date Setting" on page 60. Set the
present time."
Memory" on page 82. Set the alarm area.)
Recording
••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
10
Copying the data to a copy device.
Data Management Setting for Main
Setting the alarm area in the main device
Searching recorded data using the alarm list
Connections
• Connections for camera, monitor, and sensor.
See " Connecting to CCTV camera, monitor,
and sensor" on page 17.
• Connection for the alarm recording.
See " Alarm recording connection" on page
18 and " Rear view" on pages 15, 16.
Boot-up the unit
When executing Setup Wizard:
See " Setup Wizard" on pages 30, 31.
Only when the unit is turned on for the first time, the
<Setup Wizard> screen is displayed automatically. It
is not displayed next time.
• The language, present time, HDD configuration, and
recording settings are set automatically by following
the instructions in the menu.
Making the initial menu settings
• Setting the present time display mode.
See " On Screen Information" on page 69.
• Setting the audio recording.
See " Audio Recording Setup" on page 55 and
" Continuous recording time table" on pages 110, 111.
Making the HDD settings
• Setting the repeat recording.
See " Data Management Setting for Main
Memory" on page 82.
• Setting the remaining HDD capacity.
See "Low Memory Alarm Setting" on pages 60
and 61.
• Setting the CALL OUT.
See " Call Out Settings" on pages 60 and 61.
• Setting the buzzer.
See " Buzzer" on page 61.
Making the multiplexer settings
• Making the split screen settings.
See " Multiplexer Setting" on pages 66, 67.
• Making the sequence setting.
See " Multiplexer Setting" on pages 66, 67.
Setting other various functions
• Setting the camera title/recorder title.
See " Camera Title" and " Recorder Title" on
page 69, 70.
• Setting the display mode.
See " On Screen Information" on page 69.
• Setting the output signal of the unit status.
See " Mode Out Settings" on pages 60 and
61.
Making the