Flowchart; Flowchart For Connection And Settings - Mitsubishi Electric DX-TL910U Installation And Operation Manual

Flowchart

I Flowchart for connection and settings
Installation example :
This is an example operational flowchart of the following : making connections at the rear of the terminal ; setting
HDD mode to PARTITION ; making default settings ; making an Alarm recording with Timer mode ; searching
recorded data with ALARM LIST SEARCH ; using playback, and copying to a Compact Flash Card.
Connection to the terminals on the back
• Connection to the terminals on the back.
monitor, sensor", page 19.
• Connection to the alarm recording.
See "I Alarm Recording Connection",
page 20 and "I Rear View" , pages 17,18.
The unit is booted
AUTO SET UP
• Setting the auto set up.
See "I AUTO SET UP", pages 21,22.
Only when the unit is turned on for the first time, the
<AUTO SET UP> screen is displayed automatically. It is not
automatically displayed after next time.
Selecting the "YES" in "PERFORM AUTO SET
UP?" setting.
Recording
•••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••••
12
See "I Connecting to CCTV camera,
Connection to the terminals on the back
• Connection to the terminals on the back.
See "I Connecting to CCTV camera,
monitor, sensor", page 19.
• Connection to the alarm recording.
See "I Alarm Recording Connection",
page 20 and "I Rear View" , pages 17,18.
The unit is booted
AUTO SET UP
• Setting the auto set up.
See "I AUTO SET UP", pages 21,22.
Only when the unit is turned on for the first time, the
<AUTO SET UP> screen is displayed automatically. It is not
automatically displayed after next time.
Selecting the "NO" in "PERFORM AUTO SET
UP?" setting.
Making the HDD REC SETTING
• Setting the PARTITION. "o PARTITION/PARTITION SIZE"
default settings "NORMAL" } } } } } "PARTITION".
See "o PARTITION/PARTITION SIZE", page 79.
Changing the initial menu settings
• Setting the present time and screen display.
See "<TIME DATE/DISPLAY SETTINGS>",
pages 36-38.
• Setting the present time.
See "o TIME DATE ADJUST", pages
24,25.
• Setting the display mode.
See "I DISPLAY MODE", page 36.
• Setting the audio recording.
See "I AUDIO RECORDING", page 52 and
"I Continuous recording time table", pages
87,88.
Setting the HDD (hard disk drive) mode
• Setting the repeat recording.
See "o HDD REPEAT REC MAIN/HDD
REPEAT REC SUB", page 51.
• Setting the remain HDD capacity.
See "o REMAIN HDD", page 54.
• Setting the call out.
See "• HDD MAIN REMAIN/HDD SUB
REMAIN", pages 54,55 and "• HDD MAIN FULL/
HDD SUB FULL", page 55.