Making Drinks With Milk; Filling And Attaching The Milk Container; Making Cappuccino Of Latte Macchiato; Making Frothed Milk (Without Coffee) - DeLonghi ESAM04.350 Instructions For Use Manual

Bean to cup espresso and cappuccino machine
Table of Contents

Advertisement

it. This could damage the appliance.
Never use more than one level
measure or it could dirty the inside
of the machine or block the funnel.
Please note!
if you use pre-ground coffee, you can only make one cup of
coffee at a time.
1. Press the
(C11) button: "Pre-ground" flashes on
the display.
2. Put one level measure of pre-ground coffee into the
funnel (fig. 14).
3. Place a cup under the coffee spouts (fig. 9).
4. Press the
delivery button (fig. 2).
5. Preparation begins. a bar appears on the display and
gradually fills as preparation progresses.
once the coffee has been made, the appliance prepares for
use again.To disable the pre-ground coffee function, press the
or
button again.

MAKING DRINKS WITH MIlK

Please note!
To avoid producing milk with poor froth or large bubbles,
always clean the milk container lid and hot water nozzle as
described in the section "Cleaning the milk container" and
"Cleaning the hot water/steam nozzle" (page 16).

Filling and attaching the milk container

1. remove the lid (fig. 16);
2. Fill the milk container with a sufficient quantity of milk,
not exceeding the MAX level marked on the handle (fig.
17).
Please note!
For a denser more even froth, you must use skimmed or
partially skimmed milk at refrigerator temperature (about
5°C).
The quality of froth can be adjusted during delivery
by moving the regulator slightly towards the word
CAFFElATTE for less froth.
Moving it towards the word CAPPUCCINO obtains a
more froth.
If "Energy Saving" mode is enabled, you may have to wait
a few seconds before the first cappuccino is delivered.
3. Make sure the milk intake tube is correctly inserted in the
4. Place the lid back on the milk container.
5. remove the hot water spout from the nozzle (fig. 19).
6. attach the container to the nozzle, pushing as far as it will
7. Follow the instructions for each function.

Making Cappuccino of latte Macchiato

1. attach the milk container (see previous section) and place
2. Place the frothed milk regulator between "CaPPuCCino"
3. Press the CAPPUCCINO button (fig. 22). "CaPPuCCino"
4. after a few seconds, frothed milk flows out of the milk
5. The cappuccino is ready. Sweeten to taste and, if desired,

Making frothed milk (without coffee)

To make frothed milk, proceed as described in the previous
section, placing the milk froth regulator in the CaPPuCCino
position and pressing the CAPPUCCINO button twice
consecutively (within two seconds) (fig. 22).
The appliance displays "Frothed milk" .
if during delivery you want to stop making milk or coffee, press
- froth
the CAPPUCCINO button once.

Preparing milk (unfrothed and without coffee)

+ froth
Proceed as described in the previous section, placing the milk
froth regulator in the CaFFelaTTe position.
13
during this time, "Preparation underway..." is displayed.
bottom of the milk container lid (fig. 18).
go (fig. 20).
a sufficiently large cup under the coffee spouts and milk
spout.
and "CaFFelaTTe" (fig. 21).
is displayed, together with a progress bar which fills
gradually as preparation proceeds.
spout into the cup below. if the froth is not satisfactory,
move the milk regulator towards "CaPPuCCino" (= +
froth) or towards "CaFFelaTTe" (= - froth). Milk delivery
stops automatically and coffee delivery begins.
sprinkle the froth with a little cocoa powder.
Please note!
If you want to interrupt preparation during delivery, press
the CaPPuCCino button.
At the end of delivery, to increase the quantity of coffee
in the cup, just press (within 3 seconds) the CaPPuCCino
button.
do not leave the milk container out of the refrigerator for
longer than strictly necessary. The warmer the milk (5°C
ideal), the poorer the froth will be.
Please note!

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents