ElECTRICAl REqUIREMENTS Before using this appliance ensure that the voltage indicated on the product corresponds with the main voltage in your home, if you are in any doubt about your supply contact your local electricity company. The flexible mains lead is supplied connected to a B.S. 1363 fused plug having a fuse of 13 amp capacity. Should this plug not fit the socket outlets in your home, it should be cut off and replaced with a suitable plug, following the procedure outlined below.
CONTENTS Measuring water hardness ............15 Set water hardness ..............15 INTRODUCTION ............7 TECHNICAl SPECIFICATION ........15 Symbols used in these instructions .......... 7 letters in brackets ..............7 DISPOSAl ..............15 Troubleshooting and repairs ............. 7 MEANING OF lIGHTS DURING NORMAl OPERATION .16 SAFETY ..............7 Fundamental safety warnings ..........
INTRODUCTION SAFETY Thank you for choosing the „eSaM04.120“ bean to cup coffee Fundamental safety warnings maker. Danger! To get the best result of your new coffee machine please read This is an electrical appliance and may therefore cause electric these instructions carefully before use. This should ensure op- shock.
environments; B2. Temperature oK or 1 cup coffee light button: to make 1 cup of coffee • farm houses B4. Temperature oK or 2 cup coffee light • by clients in hotels, motels and other residential type en- B5. Tasto : to make 2 cups of coffee vironments B6. Temperature oK for steam light •...
pliance. The appliance is ready for use only after completion of this Connect the appliance to an efficiently earthed and correctly cycle. installed socket with a minimum current rating of 10a only. Danger of burns! if the power socket does not match the plug on the appliance, during rinsing, a little hot water comes out of the coffee spouts have the socket replaced with a suitable type by a qualified and is collected in the drip tray underneath.
15min 30min 3. Press the ECO button to confirm the selection: auto-off is programmed. Please note : Please note: • The first time you use the appliance, you will need to To disconnect the appliance completely, place the main switch make a number of coffees to identify the correct dial posi- at the back of the appliance in the 0 position (fig.
if the coffee is delivered too slowly or Please note: not at all, turn one click clockwise. For hotter coffee, see the section “Tips for a hotter coffee”. For fuller bodied creamier coffee, turn one click anticlockwise (do Important! not turn more than one click at a •...
Cleaning the cappuccino maker after use. For a richer denser froth, use skimmed or partially skimmed milk at refrigerator temperature (about 5°C). Clean the cappuccino maker each time you use it to avoid the To avoid milk with poor froth or large bubbles, always build-up of milk residues or blockages.
ClEANING cleaned. To remove the drip tray: 1. remove the drip tray and the grounds container (fig. 18); Cleaning the coffee maker 2. empty the drip tray and grounds container and wash The following parts of the machine must be cleaned regularly: them;...
do not use washing up liquid to clean the infuser as it could litres under the hot water spout. cause damage. 4. Wait for the lights to come on stead- 5. Soak the infuser in water for about 5 minutes, then rinse ily.
2. immerse the paper completely in a glass of water for one • Low Voltage Directive 2006/95/EC and subsequent second. amendments; 3. remove the paper from the water and shake lightly. after • EMC Directive 2004/108/EC and subsequent amend- about a minute, 1, 2, 3, or 4 red squares form, depending ments on the hardness of the water.
MEANING OF lIGHTS DURING NORMAl OPERATION lIGHTS DESCRIPTION MEANING The lights flash The water is not yet at the ideal temperature. Wait for the lights to come on steadily before ma- king coffee The lights are on steadily The appliance is ready to make coffee The light is on steadily The appliance is delivering one cup of coffee The light is on steadily...
MEANING OF THE AlARM lIGHTS lIGHTS DESCRIPTION MEANING WHAT TO DO The light is on steadily Insufficient water in the tank or Fill the tank with water and insert it correct- the tank is not correctly inserted ly, pushing it as far as it will go until it clicks into place.
lIGHTS DESCRIPTION MEANING WHAT TO DO The light is on steadily The infuser has not been replaced insert the infuser as described in the para- after cleaning. graph “Cleaning the infuser” The inside of the appliance is very Clean the appliance thoroughly dirty The light flashes The service door is open...
Page 20
PROBlEM POSSIBlE CAUSE SOlUTION Steam delivery stops • a safety device stops steam delivery after 3 minutes. • Wait, then activate the steam function again. The appliance does not come • it is not plugged into the mains socket. • Plug into the mains socket.