Identifying The Adapter Components; Connecting The Adapter - HP ENVY 13 User Manual

Identifying the adapter components

Component
(1) Adapter light
(2) RJ-45 (network) jack
(3) Reset button
(4) Power cord connector

Connecting the adapter

1. Plug the power cord into the power cord connector (1) on the Voodoo Power Adapter.
2. Plug the power cord into an AC wall outlet (2).
3. Plug an RJ-45 network cable (purchased separately) into the network jack (3) on the adapter.
18 Chapter 3 Wireless and local area network
Description
●
AC adapter only (no RJ-45 network cable connected):
◦ Off: The light is off when the adapter is plugged into a wall outlet.
◦
Blinking: The light blinks once after approximately one minute,
and then turns off.
●
AC adapter and network (an RJ-45 network cable is connected):
◦
Off: The light is off when the adapter is plugged into a wall outlet.
◦
Blinking: The light blinks once after approximately one minute
to signal the start of wireless broadcasting. The light then blinks
periodically every few seconds until the pairing between the
computer and the Voodoo Power Adapter occurs.
◦ On: The light stays on after contact is established.
Connects an optional network cable (purchased separately).
Re-synchronizes the wireless connectivity to the adapter.
NOTE: If you reset the adapter, you will have to repeat the setup steps.
Connects the power cord to the Voodoo Power Adapter.