Battery Charging And Discharging Sequence; Calibrating A Battery - HP ENVY 13 User Manual

3. Lift the accessory battery from the bottom of the computer (2).

Battery charging and discharging sequence

Battery charging and discharging sequence varies when both the primary battery and optional accessory
battery are installed.
●
The computer supports Fast Charge Mode (enabled at the factory). When both batteries are
charging, the primary battery will charge to 90 percent before the accessory battery begins
charging. Charging is then switched to the accessory battery. When the accessory battery reaches
90 percent, the primary battery will then charge to 100 percent. After the primary battery is
completely charged, the accessory battery will charge to 100 percent.
NOTE:
disabled, the primary battery will charge to 100 percent before the accessory battery begins
charging. Refer to
● When the accessory battery reaches a critical battery level, battery power is transferred to the
primary battery.
●
The accessory battery will discharge before the primary battery discharges.
● When the accessory battery is removed from the computer, battery power is transferred to the
primary battery.
●
When the accessory battery is inserted in the computer, battery power is transferred to the
accessory battery.

Calibrating a battery

To maximize battery performance, you should calibrate a battery under the following conditions:
●
When battery charge displays seem inaccurate
●
When you observe a significant change in battery run time
52 Chapter 6 Power management
Fast Charge Mode can be disabled in Setup Utility (BIOS). If Fast Charge Mode is
Setup Utility (BIOS) on page 70 for additional information.