Supermicro H8DSP-8 User Manual page 54

H8DSP-8/H8DSP-i User's Manual
User Confi guration Mode
Options are Auto and Manual.
Bank Interleaving
This setting is used to determine whether bank interleaving is to be employed.
The options are Auto and Disabled.
Burst Length
Use this setting to set the memory burst length. 64-bit Dq must use 4 beats.
Options are 8 beats, 4 beats and 2 beats.
Enable Clock to All DIMMs
This setting allows the user to enable unused clocks to DIMMs, even if DIMM
slots are empty. Options are Enabled and Disabled.
Hardware Memory Hole
When "Enabled", allows software memory remapping around the memory hole
(only supported by rev. E0 processors and above). Options are Enabled and
Disabled.
Node Interleaving
Use this setting to Enable or Disable node interleaving.
ECC Confi guration
DRAM ECC Enable
DRAM ECC allows hardware to report and correct memory errors automati-
cally. Options are Enabled and Disabled.
MCA DRAM ECC Logging
When "Enabled", MCA DRAM ECC logging and reporting is enabled.
Options are Enabled and Disabled.
ECC Chip Kill
Allows the user to Enable or Disable ECC Chip Kill.
4-8