Care And Cleaning; What To Do If - Zanussi ZGL62I User Manual

Care and cleaning

Warning! Switch the appliance off and let it cool
down before you clean it. Disconnect the appliance
from the electrical supply, before carrying out any
cleaning or maintenance work.
Warning! For safety reasons, do not clean the
appliance with steam cleaners or high-pressure
cleaners.
Warning! Do not use abrasive cleaners, steel wool
pads or acids, they can cause damage to the
appliance.
• You can remove the pan supports to easily clean the
hob.
• To clean the enamelled parts, cap and crown, wash it
with warm soapy water.
• Stainless steel parts wash with water, and then dry with
a soft cloth.
• The pan supports are not dishwasher proof; they must
be washed by hand .
• When you wash the pan supports by hand, take care
when you dry them as the enamelling process occa-
sionally leaves rough edges. If necessary, remove
stubborn stains using a paste cleaner.

What to do if...

Problem
There is no spark when lighting the
gas
The gas ring burns unevenly
If there is a fault, first try to find a solution to the problem
yourself. If you cannot find a solution to the problem
yourself, speak your dealer or the local Service Force
Centre.
• Make sure you position the pan supports correctly after
• To make burners work correctly, make sure that the
• Be very careful when you replace the pan supports to
After cleaning, dry the appliance with a soft cloth.
The stainless steel can become tarnished if it is too much
heated. Refer to this you must not cook with potstones,
earthenware pans or cast iron plates. Do not use alumini-
um foil to prevent damage the top during operation.
Cleaning of the spark plug
This feature is obtained through a ceramic ignition candle
with a metal electrode. Keep these components well clean
to prevent difficult lighting and check that the burner
crown holes are not obstructed.
Periodic maintenance
Periodically speak your local Service Force Centre to
check the conditions of the gas supply pipe and the pres-
sure adjuster, if fitted.
Possible cause
• There is no electrical supply
• Burner cap and crown are placed
uneven
• Burner crown is blocked with food
residues
neer, the visit from the customer service technician or
cleaning.
arms of the pan supports are in the centre of the burn-
er.
prevent the hob top from damage.
• Make sure that the unit is connec-
ted and the electrical supply is
switched on.
• Control the fuse. If the fuse is re-
leased more than one time, refer
to a qualified electrician.
• Make sure that the burner cap and
crown are in correct positions.
• Make sure that the injector is not
blocked and the burner crown is
clear of food particles.
If you operated the appliance incorrectly, or the in-
stallation was not carried out by a registered engi-
Remedy
9