Table of Contents
Advertisement
35 Res Save Off
Deficient Memory
What this message means:
The printer lacks the memory needed to enable Resource Save. This message usually
indicates too much memory is allocated for one or more of the printer link buffers.
What you can do:
•
Press
•
To enable Resource Save after you get this message:
–
–
•
Install additional memory.
37 Insufficient
Collation Area
What this message means:
The printer memory (or hard disk, if installed) does not have the free space necessary to
collate the print job.
What you can do:
•
Press
•
Press
37 Insufficient
Defrag Memory
What this message means:
The printer cannot defragment flash memory, because the printer memory used to store
undeleted flash resources is full.
What you can do:
•
Delete fonts, macros, and other data in printer memory.
•
Install additional printer memory.
Argecy Computer Corporation 248-324-1800
to disable Resource Save and continue printing.
Go
Make sure the link buffers are set to Auto, and exit the menus to activate the link buffer
changes.
When Ready is displayed, enable Resource Save from the Setup Menu.
to print the portion of the job already stored and begin collating the rest of the job.
Go
to open the Job Menu and cancel the current job.
Menu
104
Advertisement
Table of Contents
