4.0 CONNECTING THE ANTENNA 1.0 INTRODUCTION Thank you for purchasing the STRONG SRT ANT 10 ECO DVB-T/T2 Antenna. This antenna has been specially designed to receive digital terrestrial signals from the air. It can be connected to any Digital Terrestrial Receiver (DVB-T/T2), and is designed for INDOOR use only.
3.0 SAfETY NOTES before you make any connections: disconnect your equipment from the 230 V main power to avoid electric shocks during installation. Short circuit in the cable MAY permanently damage your Digital Receiver. Never install the antenna outside your house or in humid rooms such as bathrooms. ...
The best position can be found by trying different locations. NOTE: It is recommended NOT to place the antenna near to: Devices that are strong source of radiation or interference such as DECT and GSM telephones, transmitters, microwaves, etc.
Page 5
In case this option is not supported by your Digital Receiver you need to connect an external power supply to power the antenna. Ask your electronic dealer for an external 230 V AC to DC power adapter that supplies 12 V DC, 250 mA. Note that the + and the – of the power adaptor are located as follows: The connector for the external power supply can be found at the backside of the antenna.