Advertisement
In case this option is not supported by your Digital Receiver you need to connect an external power
supply to power the antenna. Ask your electronic dealer for an external 230 V AC to DC power adapter that
supplies 12 V DC, 250 mA. Note that the + and the – of the power adaptor are located as follows:
The connector for the external power supply can be found at the backside of the antenna.
NOTE:
The antenna will not function properly if the built-in amplifier is not powered.
Therefore it is required to supply the antenna with power via the RF cable or via an
external adapter.
Extension of the RF cable:
In some cases you may need to extend the standard supplied RF cable, we advise you to only do this if you
can't get optimal signal strength within the reach of the standard cable. If you are to extend the RF cable,
then please note following comments:
Use a good quality RF cable, 75 Ohm type only with proper shielding
„
„
Use well shielded connectors, your dealer can advise you on this.
„
„
Make sure that both inner cable and shielding are properly connected to the connectors to
„
„
assure active antenna power supply and to avoid short circuit in the cable.
If you extend the cable, please keep the cable as short as strictly needed. Extending the cable or using a
bad quality cable will reduce the performance of your antenna.
4
Advertisement
