12
12.4 Reading Boot Messages
DC power (green)
System running
12-10
Use the boot software messages to verify the presence of options in the
system. After POST completes the system self-test, a message similar to
the following will appear on your screen. The message lists hardware
detected in the system.
Note – The following screen display is only an example. The actual message
displayed on the screen will vary with the software running on the system.
16-slot Ultra Enterprise 6000, Keyboard Present
OpenBoot -.- FCS, --- MB memory installed, Serial #---.
Ethernet address -:-:--:-:--:--, Host ID: ------.
If there is no terminal on this system, you must check the system status by
inspecting LEDs on the front panel. See Figure 12-8 and Figure 12-9.
Fault (yellow)
(green)
Figure 12-8 Front Panel Status LEDs (Cabinet Server)
Ultra Enterprise 6000/5000/4000 Systems Manual—November 1996