Section 6: Maintenance; Schedule; Cleaning And Protecting; Lubrication - Grizzly G0758 Owner's Manual

Mill/drill
Table of Contents

Advertisement

SEctION 6: MaINtENaNcE

to reduce risk of shock or
accidental startup, always
disconnect machine from
power before adjustments,
maintenance, or service.

Schedule

For optimum performance from the machine, fol-
low this maintenance schedule and refer to any
specific instructions given in this section.
Daily check:
loose mounting bolts.
damaged tooling.
Clean debris and built up grime off of machine.
Worn or damaged wires.
any other unsafe condition.
Every 8 hours of Operation:
lubricate table and column ways (page 29).
lubricate quill outside surface (page 31).
Every 40 hours of Operation:
lubricate table leadscrews (page 30).
Every 90 hours of Operation:
headstock gears (page 30).
lubricate quill rack (page 31).
Every 120 hours of Operation:
lubricate column leadscrew (page 29).
-28-
cleaning and
protecting
Metal chips left on the machine that have been
soaked with water-based coolant will invite oxida-
tion and a gummy residue build-up around the
moving parts. use a brush and shop vacuum to
remove chips and debris from the working sur-
faces of the mill/drill. never blow off the mill/drill
with compressed air, as this will force metal chips
deep into the mechanisms and may cause injury
to yourself or bystanders.
remove any rust build-up from unpainted cast
iron surfaces of mill/drill and treat with a non-
staining lubricant after cleaning.
protect other unpainted cast iron surfaces with
regular applications of products like g96
treatment, slipit
, or Boeshield
®
accessories on page 27 for more details.)

Lubrication

an essential part of lubrication is cleaning the
components before lubricating them.
this step is critical because grime and chips build
up on lubricated components over time, which
makes them hard to move.
Clean all exterior components in this section with
mineral spirits, shop rags, and brushes before
lubricating.
disConneCt
MaChine
BeFore perForMing luBriCation!
follow reasonable lubrication practices as
outlined in this manual. failure to do so
could lead to premature failure of machine
and will void warranty.
Model G0758 (Mfd. Since 2/14)
gun
®
t-9. (see
®
FroM
poWer

Advertisement

Table of Contents
loading

Table of Contents