Table of Contents
Advertisement
Quill Outside Surface
lube type .. Model sB1365 or iso 68 equivalent
lube amount ........................................thin Coat
lubrication Frequency ........... 8 hrs. of operation
to lubricate quill:
1.
Without disturbing grease on quill rack, clean
outside smooth surface of quill (see figure 41)
with mineral spirits and shop rags.
Quill outside
surface
figure 41. outside surface of quill.
2.
When dry, apply thin coat of lubricant to
smooth surface, then move spindle up and
down to evenly distribute oil.
Quill Rack
lube type ..Model t23964 or nlgi#2 equivalent
lube amount ........................................thin Coat
lubrication Frequency ......... 90 hrs. of operation
to lubricate quill rack:
1.
Move quill down to gain full access to quill
rack (see figure 42).
figure 42. Quill rack location.
Model G0758 (Mfd. Since 2/14)
2.
Clean teeth with mineral spirits, shop rags,
and brush.
3.
When dry, apply thin coat of grease to teeth
and raise/lower quill several times to evenly
distribute.
Note: Re-apply oil that may have been
removed during the cleaning process to the
quill surface around the rack.
Replacing DRO
if the dro stops operating correctly, the 3V lithi-
um cell battery must be replaced.
to replace DRO battery:
1.
using a #3 standard screwdriver, remove
battery cover (see figure 43) by rotating
counterclockwise.
figure 43. Battery cover for dro.
2.
remove old battery, dispose of it according
to state and federal regulations, then replace
it with a new one.
rack
3.
replace battery cover.
battery
Battery Cover
-31-
Advertisement
Table of Contents
