Idle Speed Adjustment; Throttle Cable Adjustment; Fuel Hose Inspection - Coleman PowersportsCT200U Owner's Manual

Idle speed adjustment

The idle speed should be set at 1700 ±
150 RPMs
To adjust the idle speed:
1. locate the idle adjustment screw (1)
located on the carburetor.
2. Allow the engine to warm up
approximately 10 minutes
3. With the engine running, turn the idle
adjustment screw in or out at small incre-
ments until the correct idle is achieved.
Note: A service center can perform this
adjustment . A diagnostic tachometer is
required for this adjustment.

Throttle Cable adjustment

It is important that the throttle grip have a
certain amount of free play so the throttle
does not rise when the handlebars are
turned from left to right.
The hand grip throttle free play (2) should
be .078 - .24 in (2-6 mm)
To adjust freeplay
1. Loosen jam nut (3)
2. Turn adjusting nut (4) to proper setting
3. Once throttle grip is at the proper
freeplay, re-tighten the jam nut (3).
NOTE: After any adjustment, make sure
throttle snaps back to idle when released.

Fuel Hose Inspection

Inspect the fuel hose for any cracks or
leaks and make sure all clamps are in
place. Replace the fuel hose if any de-
fects are found.
MAINTENANCE
4
!
Inadequate throttle play can be
hazardous
The engine speed could rise when
the handlebars are turned if there
is not enough throttle play. This
could result in loss of control.
Always check throttle play before
each ride. Turn handlebars from
side to side making sure throttle
does not increase when doing so.
21
1
3
WARNING
.078 - .24 in
(2-6 mm)
2