Spark Plug - Coleman PowersportsCT200U Owner's Manual

Spark Plug

This Mini Bike comes equipped with a
LD- F7TC spark plug.
To inspect the spark plug, remove the air
filter cover and element to gain access.
Remove spark plug cap (1) then remove
the spark plug from the engine with the
spark plug tool provided.
Inspect the plug for carbon deposits and
clean if necessary. If plug shows exces-
sive carbon, replace the plug.
CAUTION
Dirt can damage the engine if it
enters the spark plug hole.
Make sure the spark plug hole is
covered after removing plug.
Use a thickness feeler to inspect the spark
plug gap (2). The spark plug gap should be
0.6 - 0.8mm (0.024 - 0.032 in.)
Re-install the inspected plug or new plug
until finger tight. Finish tightening plug
with a wrench. If the plug is a new plug,
tighten approximately 1/2 turn more
with the wrench. If plug is an old plug,
tighten approximately 1/8 turn more with
a wrench.
MAINTENANCE
0.6 - 0.8 mm
(0.024 - 0.032 in)
19
1
LD F7TC
2