Engine Oil; Checking; Changing - Coleman PowersportsCT200U Owner's Manual

Engine Oil

The proper amount and grade of engine oil
will have a great impact on the life of the
engine. Checking the oil daily and
changing the oil as listed in the
maintenance schedule is the most
important maintenance procedure for the
engine.
Checking the engine oil
1. Make sure the Mini Bike is on level
ground.
2. Check engine oil level by removing the
oil fill plug/dipstick (1) located on bottom
front left front side of the engine.
3. If engine oil is low, add oil until oil is at
edge of fill hole (2). Use the correct grade
of oil as listed in this manual. Do not
over or under fill engine with oil, this could
damage the engine.
Changing the engine oil
1. Make sure engine is warm before
attempting to drain the oil. A warm engine
will help the oil drain quicker.
2. Remove the oil fill plug (1)
3. Remove the drain bolt (3) located on
the bottom of the engine.
4. Allow the oil to drain in an appropriate
container. Note: Dispose of oil at an oil
recycle center.
5. Install the drain plug and fill with the
appropriate type of oil as listed in this
manual. This mini bike takes .63qt. (.6L)
of engine oil.
6. Re- install fill cap, Start engine and
allow to run for a few minutes, Re-check
oil level and fill accordingly.
MAINTENANCE
!
New and used oil can be hazardous
Children and pets can be harmed
by swallowing new or used oil.
Continuous contact with used
engine oil has been found to cause
skin cancer in laboratory animals
Always keep new or used oil away
from children and pets.
20
WARNING
1
1
3
2