Telstra 7200 User Manual page 18

Using your answering machine (Telstra 7200a only)
The prompt will announce "Please speak after
the tone. To end recording, release the button."
3. Record your outgoing message by speaking into
the base unit (approx. 40 cm). When finished,
release the button.
You new outgoing message will be played back.
To record your own Answer and Record
outgoing message via the handset
1. Press
2.Scroll to TAM SETTINGS. Press to
confirm
to OGM SETTING and press
3.Scroll to
confirm.
to RECORD OGM.
4. Scroll
5. Scroll to ANS & REC and press to confirm
The prompt will announce " Please speak after
the tone. To end recording, press square.
6. Record your outgoing message. When finished
34
7200-7200a-2 colmn UG.indd 34-35 7200-7200a-2 colmn UG.indd 34-35
press the key.
Your new outgoing message will be played back
to you.
To record you own Answer Only outgoing
message
You can record your own Answer Only outgoing
message to use instead of the pre-recorded
message already available. Your outgoing
message can be up to a maximum recording
capacity (3 minutes), but you should try to keep
it short to allow time for recording memos, or
incoming messages when using the alternative
Answer and Record outgoing message. Your own
outgoing message will replace the Answer Only
pre-recorded outgoing message, but it is possible
to reinstate it later if you wish (see page 36).
1. Press and hold the button until you hear,
"Please select outgoing message".
2. To record your own Answer Only outgoing
message, press and hold button.The prompt
Using your answering machine (Telstra 7200a only)
will announce, "Please speak after the tone. To
end recording, release the button."
3. Record your outgoing message by speaking into
the base unit (approx. 40 cm). When finished,
release the button. Your new outgoing
message will be played back to you.
To record your own Answer only message
via the handset
1. Press
to TAM SETTINGS. Press
2.Scroll to
confirm
3.Scroll to OGM SETTING and press to
confirm.
4. Scroll to RECORD OGM.
Note:
When recording your own Answer Only
outgoing message, please remember not to invite
your caller to leave a message, as the Answer Only
mode will not record incoming messages.
5. Scroll to ANS ONLY and press to
confirm.
The prompt will announce "Please speak after
the tone. To end recording, press square.
6. Record your outgoing message. When finished
press the key.
Your new outgoing message will be played back
to you.
To check or play your outgoing message
You can check and play back your current
outgoing message at any time via your base unit
or handset.
On the Base
Press the button. The prompt will announce
either: "Answer on....." and play your currently
selected outgoing message.
Or
"Answer off". If prompt is "Answer off", press the
button again and the prompt will
announce the current outgoing message.
35
24/10/07 12:19:04 PM 24/10/07 12:19:04 PM