Hitachi SICOLOR DIG K550 Operation Manual page 43

The enhancer is fixed during EXPOSURE operation. Even if the setting is adjusted, the
enhancer function does not change.
l
Negative/Positive select
The data transfer rate can be selected for either 9600 bps or 2400 bps.
To change the setting from 9600bps to 2400bps, switch off the camera power. then hold
the right direction button depressed and switch the power on.
This will change the setting to 2400bps.
Conversely, to change the setting from 2400bps to 9600bps, hold the left direction button
depressed while switching the power on.
Initialize
The following items are changed by the Initialize command.
l
ID indication: On (however, when power is cut, then returned, the state prior to
Initialize is returned)
l
TEXT DISPLAY: Off (however, when power is cut, then returned, the state prior to
Initialize is returned)
l
LIGHT CONTROL MODE:LENS
l
Shutter limit no.of AES&LENS mode :1/1000 sec
l
CONTRAST :OFF
l
AREA SELECT NO.:NO.1
l
ALC-LEVEL:Cursor is returned to center
l
AGC ON max gain :31dB
l
WHITE BALANCE MODE:ATW
l
If Manual, R and B gain: Standard (Cursor is returned to center)
l
SHUTTER SPEED :1/50
l
H-PHASE:Cursor is returned to on the forth dot from left.
l
SC-PHASE COARSE:3
l
SC-PHASE FINE: Cursor is returned to on the forth dot from left.
l
EXPOSURE MODE:OFF
l
EXPOSURE TIME:2 fields
l
N.R.:OFF
l
ELE-ZOOM: WIDE (standard 1)
l
Gamma:ON
l
Negative/Positive:Positive
Initialize by simultaneously pressing the up, down, left and right buttons for longer than 3
seconds.
31