Text Display; Light Control Menu - Hitachi SICOLOR DIG K550 Operation Manual

Text display

A maximum of 24 alphanumeric characters (1 line) can be displayed on the screen. TEXT
DISPLAY ON/OFF can be selected at the MAIN MENU.
1)Press the Set button for longer than 2 seconds to display the MAIN MENU.
2)Change the SET indication from CLOSE to OPEN (to enable memory write).
3)Press the Down button to position the cursor at TEXT DISPLAY.
4)Press the Right (or Left) button to select TEXT DISPLAY ON/OFF.
Note: Characters can not be input by rear panel set up buttons.
Input the characters by remote control from a personal computer.
After adding and changing text
Be sure to again set the display position (LOCATE) after adding to or changing the text.

Light control menu

The LIGHT CONTROL mode can be selected for the following 3 modes.
The usable mode differs according to type of auto iris lens type. Refer to the table and
select the appropriate mode.
Lens drive type LENS
¡
VIDEO
¡
DC
¡: Usable mode
5: Avoid using, hunting can occur
The factory setting is LENS. To change the setting, select the mode with the left/right
buttons and press the Set button.
l
Light control mode selection
Press the Set button for longer than 2 seconds to display the MAIN MENU.
1)
LIGHT CONTROL mode
AES AES&LENS
5
¡
14
5
¡