Connect The Scsi, Network, And Parallel Cables - HP 9000 System Installation Manual

4. Connect the SCSI, Network, and Parallel
Cables
1. Connect your SCSI device cable to the connector labeled SCSI (Single-Ended)
2. Connect your parallel device, such as a printer, to the rear panel connector
3. Read and remove the sticker that covers the connector, then connect your LAN
NOTE
An optional AUI adapter for the LAN 10 Base-T connector is available (if special
ordered).

4. Connect the SCSI, Network, and Parallel Cables

on the server rear panel. If no SCSI cable is to be attached to the server, place or
leave the SCSI terminator (supplied with your server) on the SCSI (Single-
Ended) connector.
labeled Parallel.
cable to the LAN 10 Base-T connector at the rear of the R Class server.
R Class System Installation
2- 15