Traps - Snmp Trap Settings; Software Versions Management - CalAmp Sentry 4G-900 Operating Manual

4.4.2 Traps – SNMP Trap Settings
Use this pane to select the traps that will be supported by this Base Station.
To access the Traps pane
1. Click the Admin menu option and then the Alarms and Traps sub-menu option. From the
Alarms and Traps sub-menus choose Traps. The SNMP Traps Settings pane is displayed.
2. Select the traps to be supported by this unit as follows:
•
Set the Activation Mode of the relevant trap to True.
•
Click Apply.
Note: Use the Send Trap button to send the trap to the defined Destination Addresses.
4.5

Software Versions Management

Two software versions are stored on the Base Station s:
•
One in the Main Directory
•
One in the Secondary Directory
The Base Station can run software from either the Main or the Secondary directory as
determined by the user; however, software from the Main directory is always run upon Base
Station reboot or reset.
Therefore, it is recommended to run the desired software from the Main directory.
The software components saved in one directory can be copied to the other directory, allowing
the user to save backups of software versions and to restore or update versions as required.
This sections describes how to perform these operations, navigating between both directories
and external URL locations.
© CalAmp Sentry 4G-900 Pico Base Station 24