Table of Contents
Advertisement
Problem
The temperature in the
freezer is too high.
There is too much frost.
Technical data
Dimension
Rising Time
Voltage
Frequency
The technical information are situated in the rat-
ing plate on the internal left side of the appli-
ance and in the energy label.
Installation
Caution! Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing the
appliance.
Positioning
This appliance can be installed in a dry, well
ventilated indoor, also in a garage or cellar, but
for optimum performance install this appliance
at a location where the ambient temperature
corresponds to the climate class indicated on
the rating plate of the appliance:
10
Possible cause
The temperature regulator is not set
correctly.
Many products are stored at the
same time.
Products are too near to each oth-
er.
Food is not wrapped correctly.
The temperature regulator is not set
correctly.
Height
Width
Depth
Set a lower temperature.
Store less products at the same
time.
Store products so that there is cold
air circulation.
Wrap the food correctly.
Set a higher temperature.
1540 mm
595 mm
658 mm
18 h
230 - 240 V
50 Hz
Climate
Ambient temperature
class
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
T
+16°C to + 43°C
Location
The appliance should be installed well away
from sources of heat such as radiators, boilers,
direct sunlight etc. Ensure that air can circulate
freely around the back of the cabinet. To ensure
best performance, if the appliance is positioned
below an overhanging wall unit, the minimum
distance between the top of the cabinet and
Solution
www.zanussi.com
Advertisement
Table of Contents
