Table of Contents
Advertisement
1
Green and Yellow:
3
Brown:
5
Blue:
As the colours of the wires in the mains lead of
this appliance may not correspond with the col-
oured markings identifying the terminals in your
plug, proceed as follows:
1. Connect the wire coloured green and yel-
low to the terminal marked either with the
letter "E" or by the earth symbol
oured green and yellow.
2. Connect the wire coloured blue to the ter-
minal either marked with the letter "N" or
coloured black.
3. Connect the wire coloured brown to the
terminal either marked with the "L" or col-
oured red.
4. Check that no cut, or stray strands of wire
is present and the cord clamp
over the outer sheath.
5. Make sure the electricity supply voltage is
the same as that indicated on the appli-
ance rating plate.
6. Switch on the appliance.
The appliance is supplied with a 13 amp plug
2
fitted
. In the event of having to change the
fuse in the plug supplied, a 13 amp ASTA ap-
proved (BS 1362) fuse must be used.
Warning! A cut off plug inserted into a 13
amp socket is a serious safety (shock)
hazard. Ensure that it is disposed of safely.
Levelling
When placing the appliance ensure that it
stands level. This can be achieved by two ad-
justable feet at the bottom in front.
12
Earth
Live
Neutral
or col-
4
is secure
Door reversibility
Important! To carry out the following
operations, we suggest that this be made with
another person that will keep a firm hold on the
doors of the appliance during the operations.
To change the opening direction of the door,
do these steps:
• Remove the plug from the power socket.
• Tilt back the appliance carefully so that the
compressor cannot touch the floor.
1. Remove the plinth.
2. Unscrew and re-
move the lower hing-
es.
3. Remove the door.
2
1
4. Unscrew the upper
pin and screw it on
the opposite side.
5. Refit the door.
6. Make sure the
edge of the door is
parallel with the edge
of the top.
www.zanussi.com
Advertisement
Table of Contents
