Farm houses; staff kitchen areas in shops, offices and other – working environments By clients in hotels, motels, bed and breakfast and other – residential type environments Keep ventilation openings, in the appliance enclosure or in the • built-in structure, clear of obstruction. www.zanussi.com...
• Do not pull the mains cable to disconnect cellars. the appliance. Always pull the mains plug. www.zanussi.com...
Page 4
• Do not cause damage to the part of the damp. cooling unit that is near the heat exchanger. • Do not freeze again food that has been thawed. • Obey the storage instructions on the packaging of frozen food. www.zanussi.com...
Otherwise the compressor or that the value shown in the technical electronic components may sustain data chart under "Rising time", the damage. defrosted food must be consumed quickly or cooked immediately and then re-frozen (after cooling). www.zanussi.com...
The absence of frost is due to the continuous circulation of cold air inside the compartment, driven by an automatically controlled fan. www.zanussi.com...
• freeze only top quality, fresh and thoroughly • do not exceed the storage period indicated cleaned, foodstuffs; by the food manufacturer. • prepare food in small portions to enable it to be rapidly and completely frozen and to Troubleshooting WARNING! Refer to Safety chapters. www.zanussi.com...
Page 9
The compressor does not start This is normal, no error has oc- The compressor starts after a peri- immediately after pressing the curred. od of time. QuickFreeze, or after changing the temperature. www.zanussi.com...
This appliance can be installed in a dry, well ventilated indoor where the ambient +16°C to + 32°C temperature corresponds to the climate class +16°C to + 38°C indicated on the rating plate of the appliance: +16°C to + 43°C www.zanussi.com...
Page 11
As the colours of the wires in the mains lead of this appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: 1. Connect the wire coloured green and yellow to the terminal marked either with the 20mm www.zanussi.com...
Page 12
You can find the two spacers in the bag with 4. Unscrew the pins (3) and remove the documentation. washers. 1. Release the screw. 2. Engage the spacer below the screw. 3. Turn the spacer to the right position. 4. Tighten again the screws. www.zanussi.com...
9. Refit the plinth. 10. Stand the appliance upright. 11. Unscrew the handle (1) and fix it on the opposite side (2). Technical information Technical data Height 1850 Width Depth Rising time Hours Voltage Volts 230 - 240 Frequency www.zanussi.com...
Page 14
Return the product to your the packaging in applicable containers to local recycling facility or contact your municipal recycle it. Help protect the environment and office. human health and to recycle waste of electrical and electronic appliances. Do not dispose www.zanussi.com...