Table of Contents
Advertisement
• Screw off the pivot of the lower hinge (5) and
screw the lower hinge pivot (6) into the left
drill of the lower hinge.
6
5
• Screw off the screws of the lower hinge and
remove the hinge. (8)
• Screw off the lower cover plugs and screw
them into the hole on the opposite side. (7)
• Put the lower hinge on the opposite side and
fix it with the screws. (8)
7
8
• Place the lower door on the lower hinge piv-
ot. (9)
• Screw off the middle cover plugs and screw
them into the hole on the opposite side. (10)
• Put the middle hinge on the opposite side
and fix it with the screws. (11)
Technical data
Dimension
Rising Time
Voltage
Frequency
www.zanussi.com
11
• Place the upper door on the middle hinge
pivot. (12)
• Fix the door with upper hinge and fix it with
screws of it. (13)
13
It is advisable to wait at least four hours before
connecting the appliance to allow the oil to flow
back in the compressor.
If the ambient temperature is cold (i.e. in Win-
ter), the gasket may not fit perfectly to the cabi-
net. In that case, wait for the natural fitting of the
gasket.
In case you do not want to carry out the above
mentioned operations, contact the nearest After
Sales Service Force. The After Sales Service
specialist will carry out the reversibility of the
doors at your cost.
Height
Width
Depth
10
o
180
9
12
1845 mm
595 mm
642 mm
18 h
230-240 V
50 Hz
13
Advertisement
Table of Contents
