NordicTrack NTEX14807.1 User Manual page 10

11. Slide the Bottom Handlebar Cover (53) into the
slots on the underside of the Console (4). Attach the
Bottom Handlebar Cover to the Handlebar (7) with
two M4 x 12mm Screws (101). Then, attach the
Bottom Handlebar Cover and the Top Handlebar
Cover (20) to the Handlebar with an M4 x 16mm
Screw (77).
12. Identify the Right Pedal (21), which is marked with
an "R". Using an adjustable wrench, firmly tighten
the Right Pedal clockwise into the Right Crank
Arm (23). Tighten the Left Pedal (not shown) coun-
terclockwise into the Left Crank Arm (not shown).
IMPORTANT: Tighten both Pedals as firmly as
possible. After using the exercise cycle for one
week, retighten the Pedals.
Adjust the strap on the Right Pedal (21) to the
desired position, and then press the end of the
strap onto the tab on the Right Pedal. Adjust the
strap on the Left Pedal (not shown) in the same
way.
13. Make sure that all parts are properly tightened before you use the exercise cycle. Note: After assembly is
completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.
Plug the power supply into the socket at the front of the exercise cycle (see HOW TO PLUG IN THE
POWER SUPPLY on page 11). IMPORTANT: If the exercise cycle has been exposed to cold tempera-
tures, allow it to warm to room temperature before plugging in the power cord. If you do not do this,
the console displays or other electronic components may become damaged.
11
7
53
101
12
10
20
4
77
101
23
Strap
21
Tab