HP A165890669 User Manual page 47

CAUTION: Do not power off your workstation without first shutting down
HP–UX. Powering off with HP–UX still running could damage
the data on the disks associated with your workstation.
5.
Remove the drive and check the jumpers, as described in Removal and Replacement
Procedures at the end of this chapter.
6.
Replace the drive.
7.
Check the cable connections of your CD–ROM drive. Make sure that the connectors
are aligned and seated correctly.
8.
Recheck the device list (see the next section).
Recheck the Address Settings
Check the address settings again to see if the drive is now listed (see the "Check the
Address Settings" section, earlier in this chapter).
If the CD–ROM drive and all other SCSI–2 devices available to you before you installed
the CD–ROM drive are now listed, run the system verification test for your software
version, as explained in the next sections.
If the CD–ROM drive is still not listed, or one of the SCSI–2 devices available to you
before you installed the CD–ROM drive is still not listed, contact your service
representative.
3–7