HP A165890669 User Manual page 26

Introduction
Power Off the Workstation and any Peripherals
To power off the workstation and any peripherals, perform the following steps:
1.
Power off the workstation, using the power switch on the front of the workstation.
CAUTION: Do not power off your workstation without first shutting down
HP–UX. Powering off with HP–UX still running could damage the
data on the disks associated with your workstation.
If you are already at the boot–administration level (the level used to check the SCSI–2
IDs), you do not need to shut down before powering off.
If you accidentally rebooted HP–UX while determining the address settings, see "Prepare
the System," earlier in this chapter, for instructions on shutting down HP–UX.
2.
Disconnect the power cord from the rear of the workstation and the wall outlet.
3.
Power off any external peripherals attached to your workstation, and unplug their
power cables from the wall outlet.
You are now ready to begin the hardware installation of your new CD–ROM drive. The
step–by–step instructions for installing the drive are found in your Owners Guide.
1–16