HP A165890669 User Manual page 16

Introduction
Preparing to Install the CD–ROM Drive
The following information is provided to prepare the CD–ROM for installation.
Tools Required
The following tools are needed to install the CD–ROM drive:
#2 Phillips screwdriver
Small needle–nose pliers
Verifying Kit Contents
Verify that the kit contains one of each of the following:
CD–ROM drive (drive P/N A4325–60001)
Set of 4 screws (M4x6)
Power adapter cable
SCSI I/O cable
Static strap
HP 4x Speed CD–ROM Disk Drive User's Guide (A1658–90669)
NOTICE: If any contents of your kit are missing, contact your sales
representative.
Minimum Requirements
Minimum requirement for the HP–UX operating system is level 9.03 for the HP 4x
Speed CD–ROM drive.
NOTICE: You must use software patch PHSS_5764 under HP–UX 9.03, 9.05
and 9.07 to run SupportWave successfully.
1–6