Advertisement
-
Green
PLC
Orange On/Blink When PLC rate in 80-100Mbps, see note 1
Red
LAN
Green
Green
-
Note: The PLC LED indicator turns "ON" when powerline link is detected. If the device is serving as a
STATION, the LED indicator will blink to indicate transmit or receive powerline activity. If the device is serving as a
CCO, the LED indicator will light steadily ON, even in the presence of powerline activity
4. Hardware Installation Procedure
1. Unpack the package and verify that all the items listed in the previous
section are provided.
2. Connect the HomePlug product to the device which you want to add to a
powerline network through the Ethernet cable.
3. Plug the HomePlug product to the power outlet.
4. This device with the HomePlug will join in the powerline network
automatically.
5. Buttons :
Reset:
The Reset button can restore the factory defaults.
Group:
The button is used to synchronous the private network name.
WPS:
This button is used for enabling WPS PBC mode. If WPS is
enabled, press this button, and then the extender starts to accept
the negotiation of PBC mode
Note: Do not press the Reset button unless you want to clear the current settings. The Reset button is in a
small circular hole on the rear panel. If you want to restore the default settings, please press the Reset button gently
for 3 seconds with a fine needle inserted into the hole and then release the button. The system reboots and returns to
the factory defaults.
Off
Wi-Fi Protected Setup is disabled.
On/Blink When PLC rate﹥100Mbps, see note 1
On/Blink When PLC rate﹤100Mbps, see note 1
On
Connection succeeds.
Blink
Data is being transmitted.
Off
No LAN connection.
4
Advertisement
