Plotting Histograms, Bar Plots, And Scatter Plots; Bar Plots - HP 50g User Manual

Press „ô, simultaneously if in RPN mode, to access to the PLOT SETUP
window.
Press ˜ and type '(X^2/36+Y^2/9 < 1) (X^2/16+Y^2/9 > 1)'@@@OK@@@ to
define the conditions to be plotted.
Press @ERASE @DRAW to draw the truth plot. Again, you have to be patient
while the calculator produces the graph. If you want to interrupt the plot,
press $ , once. Then press @CANCEL .

Plotting histograms, bar plots, and scatter plots

Histograms, bar plots and scatter plots are used to plot discrete data stored in
the reserved variable DAT. This variable is used not only for these types of
plots, but also for all kind of statistical applications as will be shown in Chapter
18. As a matter of fact, the use of histogram plots is postponed until we get to
that chapter, for the plotting of a histogram requires to perform a grouping of
data and a frequency analysis before the actual plot.
show how to load data in the variable DAT and how to plot bar plots and
scatter plots.
We will use the following data for plotting bar plots and scatter plots:

Bar plots

First, make sure your calculator's CAS is in
shown above as a matrix, i.e.,
x
3.1 2.1 1.1
3.6 3.2 2.2
4.2 4.5 3.3
4.5 5.6 4.4
4.9 3.8 5.5
5.2 2.2 6.6
[[3.1,2.1,1.1],[3.6,3.2,2.2],[4.2,4.5,3.3],
y z
mode. Next, enter the data
Exact
In this section we will
Page 12-29