Sharp MD-MX30H Operation Manual page 8

(Continued)
Removing the speaker grilles
1
Remove the lower part of the speaker grille first.
2
Remove the upper part of the speaker grille.
Caution:
When the speaker grilles are removed, the speaker dia-
phragms are exposed. Make sure nothing comes into contact
with the speaker diaphragms.
Speaker cushion
Attach the cushions to the bottom of the speaker to pre-
vent it from sliding.
Placing the system
10 cm (4")
10 cm (4")
Be sure to keep space between the units for ventilation.
Keep the top and the back of this unit at least 10 cm (4")
away from the wall.
Note:
Do not place the system or speakers near a television set
as the magnetic fields produced may cause irregular co-
lours to be displayed.
*07-10
10 cm (4")
10 cm (4")
7
Connecting the AC power lead
AC 230 V, 50 Hz
To an AC socket
Connect the AC power lead to the AC INPUT socket, then
connect its plug to an AC socket.
Notes:
Unplug the AC power lead from the AC socket if the unit
will not be in use for a prolonged period of time.
Never use a power lead other than the one supplied. Use
of a power lead other than the one supplied may cause an
electric shock or fire.
Demo mode
DISPLAY
(DEMO)
When the AC power lead is first connected, the unit will
enter the demonstration mode and the words will scroll
across the display continuously.
To cancel the demonstration mode:
When in the demonstration mode, press the DISPLAY (DEMO)
button.
The demonstration mode will be cancelled and the unit
will be in the low power consumption mode.
Note:
When the unit is in the low power consumption mode, the
display will disappear.
7
00.1.13, 11:52 AM
To AC INPUT