Sharp MD-MX30H Operation Manual page 30

(Continued)
EON-TI
4
1
Tune in the desired RDS station (when a station name
is being displayed).
2
Press the EON button when "EON" appears.
"PTY TI" and "SELECT" will appear alternately for about 6
seconds.
3
Whilst they are being displayed, select the TI (Traffic
Information) by turning the jog dial.
4
Within 4 seconds, press the PTY.TI SEARCH button.
"TI" and "WAITING" will appear for 2 seconds each.
"TI" will appear, and the unit will enter the EON-TI stand-
by mode.
*23-30
3
2
EON
TI
29
5
When a TA specified starts on an ON (other network)
station, the unit will automatically switch to that sta-
tion, and "TI" will flash.
6
When the traffic announcement is over, the unit will
automatically return to the original station you were
tuned to.
If the EON button is pressed when "EON" is not displayed,
"NO EON" will appear for 5 seconds to indicate that the
unit cannot enter the EON stand-by mode.
Checking the stand-by mode setting:
When in the EON stand-by mode, press the EON button.
("TI" →"WAITING")
To cancel the EON stand-by mode:
When in the EON stand-by mode, press the EON button.
Within 4 seconds, press it again. The EON stand-by mode
will be cancelled.
"TI" will go out.
EON
Note:
If neither "TP" nor "TA" appears, then even if "EON" ap-
pears, the unit cannot enter the EON-TI stand-by mode. In
this condition, if the PTY. TI SEARCH (PTY. TI) button is
pressed after TI is selected, "NO TI" will flash for 4 sec-
onds.
29
00.1.13, 0:00 PM
TI