Table of Contents
Advertisement
4
Getting Started
A. Typical Appliance System
NOTICE: Illustrations and photos refl ect typical installations and are for design purposes only. Illustrations/diagrams are not
drawn to scale. Actual product may vary from pictures in manual
Note: Dual venting configurations
ARE NOT allowed. Appliance MUST
be vented EITHER ver tically OR
horizontally.
NON-COMBUSTIBLE ROOF FLASHING
MAINTAINS MINIMUM CLEARANCE
AROUND PIPE (SECTION 10.J)
VENT PIPE (SECTIONS 7 & 8)
CEILING FIRESTOP
ON FLOOR OF ATTIC
(SECTION 8.C and 10.G)
FRAMING/HEADER
(SECTION 5.C)
GAS LINE
(SECTION 11)
Figure 4.1 Typical System
16
Installer Guide
VERTICAL TERMINATION CAP
(SECTION 10.L)
STORM COLLAR
(SECTION 10.K)
VENT PIPE PENETRATES ROOF
PREFERABLY WITHOUT AFFECTING
ROOF RAFTERS (SECTION 8)
ATTIC INSULATION SHIELD (NOT
SHOWN) MUST BE USED HERE TO
KEEP INSULATION AWAY FROM
VENT PIPE IF ATTIC IS INSULATED
(SECTION 8.D)
Heat & Glo • 350TRSI-AUF, 350TRSILP-AUF • 2089-980 Rev. C • 10/10
HORIZONTAL
TERMINATION CAP
(SECTION 10.H)
FRAMING HEADED OFF
IN CEILING JOISTS
(SECTION 8.C)
REQUIRED ISOLATION SWITCH: AS5601
LOCATION WITHIN 1 METER OF FIREPLACE,
SUBJECT TO MANTEL PIECE, ETC. CHECK
TO ENSURE IT REMAINS CLEAR ON ANY
MANTEL PIECE INSTALLATION.
OPTIONAL
WALL SWITCH
SECTION 12.C.
HEATER MUST BE INSTALLED AND
MANTEL AND
FLUE PENETRATION COMPLETE
MANTEL LEG
PRIOR TO FINISH SHEETING
(SECTION 5.D)
SURROUND
HEARTH EXTENSION
Advertisement
Table of Contents
