Changing The Auto Load Position - Star LC-4522 User Manual

Important!
Though the Quiet Print Mode prints more quietly, it also causes printing to
take considerably longer than normal printing.
o Make sure the printer is on -line (
PRINT MODE
o Press
normal printing.
The printer emits one short beeps when the Quiet Print Mode is selected, and
two short beep when normal printing is selected.

Changing the auto load position

Normally the printer automatically feeds paper to a standard position (1/6-inch
from the top of the paper). This is called the auto load position. You can use the
following procedure to specify a different auto load position.
o Make sure the printer is off-line (
o While holding down
release the two buttons.
The printer will automatically eject the cut-sheet that is in the printer, or
reverse feed fanfold paper until it is no longer in contact with the platen.
Also, all the font and pitch indicators on the control panel will light.
MULTI-PART
o Press
o Feed the paper so the print head is located where you want the new auto
load position to be.
LINE FEED
Press
paper backward. This is the micro feed operation.
o After you have the paper at the position you want, hold down
SET/EJECT/PARK
and press
load position. The printer will beep twice to indicate that the new auto load
position is set.
o To clear the new auto load position and return to the one that you set
previously (using the above procedure), press
currently set auto load position and return to the standard position (1/6 -inch
from the top of the paper), hold down
Changing the auto load position 25
ON LINE
indicator is lit).
, to toggle between the Quiet Print Mode and
ON LINE
ON LINE PRINT MODE
, press
to feed the paper to the starting position.
to feed the paper forward and
to make the current print head position the new auto
ON LINE
indicator is not lit).
and then
SET/EJECT/PARK
ON LINE
ON LINE
. To clear the
MULTI-PART
and press
to feed the
.