Chapter 2 Hardware Installation; Led Explanation; Interfaces And Button - TP-Link TL-WA5210G User Manual

Chapter 2
2.1

LED Explanation

TL-WA5210G consists of several LED indicators, which is designed to indicate connections and
wireless signal.
View from left to right.
Name Status
Off
Power
On
Off
LAN
On
Flashing
Wireless Off
Signal
On
Strength
Note:
For Wireless Signal Strength LEDs:
In AP or Bridge mode, all the four LEDs will light up.
In Client or Repeater mode, the corresponding LED(s) will light up when the RSSI value
(wireless signal strength value) reaches the RSSI Threshold. The value of RSSI Threshold
can be set on Wireless Advanced Settings page as shown in Figure 4-26.
For example, if the RSSI value is 30, the RSSI Threshold of the four LED are 15, 25, 35, 45
respectively, and then the LEDs whose RSSI Threshold are 15 and 25 will light up.
2.2

Interfaces and button

View from left to right, the parts are explained below.
Hardware Installation
Figure 2-1 Front Panel sketch
No Power
Power on
There is no device linked to the corresponding port
There is a device linked to the corresponding port but no activity
There is an active device linked to the corresponding port
There is no remote wireless signal
Indicates the wireless signal strength of a remote AP
Figure 2-2 Rear Panel sketch
Indication
Table 2-1
4
Client or
Repeater
mode