TP-Link EAP320 Quick Installation Manual

Quick Installation Guide

AC1200/1900 Wireless Dual Band Gigabit Access Point
EAP320 / EAP330
7106505995 REV1.0.0
2

Hardware Overview

LED Indication
Solid green
The device is working properly.
Flashing red
System errors. RAM, Flash,
Ethernet, WLAN or firmware
may be malfunctioning.
4

Power Supply

EAP can be powered via a PSE device (such as a PoE switch) or a power adapter.
Via PoE Switch
PoE Switch
Connect the Ethernet cable from the PoE switch to the ETHERNET port.
1
Network Topology Requirement
EAP Controller
Controller Host
A DHCP server (typically a router) is required to assign IP addresses to the EAP and clients in your local network.
A computer running the EAP Controller software can locate in the same or different subnet with the EAPs.
Interface Panel
EAP320
EAP330
NOTE:
Flashing yellow
With the device powered on, press and hold the
Firmware update is in progress.
then release the button. The device will restore to factory default settings.
Do not disconnect or power off
the device.
ETHERNET
a PSE (Power Sourcing Equipment), such as a PoE switch, for both data transmission and Power over
Ethernet (PoE) through Ethernet cabling.
backhaul capacity.
Double-flashing red, green, yellow
CONSOLE
The device is being reset to its
information of the EAP device. CLI commands are not available in current software version. We will release a new
factory default settings.
version supporting CLI commands soon. Please pay close attention to our official website.
Via Power Adapter
Plug one end of the provided power adapter into the POWER port of the EAP and the other end to a standard
electrical wall outlet.
Internet
Router
POWER ETHERNET CONSOLE
RESET
POWER ETH1(PoE) ETH2 RESET
RESET button for about 8 seconds until the LED flashes red,
of EAP320 and ETH1 (PoE) of EAP330 is to connect to a router or a switch to transmit data or to
ETH1 and ETH2 can be combined together to double the network
is used to connect to the serial port of a computer or a terminal to check and monitor system
Switch
EAP
PoE Switch
EAP
EAP
3

Hardware Installation

The EAP can be ceiling rail mounted, ceiling-mounted, and wall-mounted.
The instructions for various mounting options are on the back of this Quick Installation Guide.
Option 1: Ceiling Rail Mounting
Option 2: Ceiling Mounting
Option 3: Wall Mounting
5

Software Configuration

To quickly set up a wireless network connection with mass EAPs, please follow the steps below.
Note: The IP address of the management computer must be reachable for the EAPs in the network.
Step 1: Installing the EAP Controller
Find the EAP Controller application file (for Windows user only) from our website at www.tp-link.com. Run the
file and follow the wizard to install the EAP Controller on the computer.
Step 2: Configuring the EAP Controller
Launch the EAP Controller and follow the configuration wizard to create a primary wireless network. After the
wizard is finished, a login screen will appear. Enter the admin name and password you created and click
Sign In.
Step 3: Adopting the EAP devices
Adopt the EAP devices in the Controller management interface to change the status from pending to connected.
For More Configurations
Now you can manage your wireless network and view network statistic using the EAP Controller. Please refer
to the EAP Controller User Guide to learn more information on configuring and using the Controller software.
Clients