TP-Link TL-WA5210G User Manual page 82

2.
Verify the wireless security parameters for all access points, if any.
3. Verify connectivity across the LANs. A computer on any LAN segment should be able to
connect to the Internet or share files and printers with any other PCs or servers connected to
any of the three WLAN segments.
Note:
You can extend this repeating by adding up to 2 additional TL-WA5210G
Wireless Outdoor CPEs
communicate in half-duplex mode, the bandwidth decreases as you add Repeaters to the network.
Also, you can extend the range of the wireless network with wireless antenna accessories.
Bridge (Point to Point) - This mode bridges the AP and another AP also in bridge mode to
connect two wired LANs. Please input the MAC address of the other AP in the field of MAC of
AP. AP function can startup also.
•
With AP mode: If you select this option, you AP will also support AP mode when it is in
Bridge (Point to Point) mode.
Here is an example of how to configure Point-to-Point Bridge. Please do the following:
1. Configure the TL-WA5210G (AP1) on LAN Segment 1 in Point-to-Point Bridge mode.
2. Configure the TL-WA5210G (AP2) on LAN Segment 2 in Point-to-Point Bridge mode. AP1
must have AP2's MAC address in its MAC Address field and AP2 must have AP1's MAC
address in its MAC Address field.
3. Configure and verify the following parameters for both access points:
•
Both use the same Channel and security settings if security is in use.
Figure 5-7 Wireless repeating
configured in repeater mode. However, since Repeater configurations
Figure 5-8 Point to Point Bridge
74
2.4GHz High Power