Table of Contents
Advertisement
Note: Heat shields MUST overlap by a minimum of 1-1/2 in. (38 mm). The heat shield is designed to be
used on a wall 4 in. to 7-1/4 in. (102 mm to 184 mm) thick. If wall thickness is less than 4 in. (102 mm)
the existing heat shields must be field trimmed. If wall thickness is greater than 7-1/4 in. (184 mm) a
DVP-HSM-B will be required.
15-1/8 in.
(384 mm)
12 in.
(305 mm)
8-1/8 in.
(206 mm)
15 in.
(381 mm)
8 in.
(203 mm)
SLP-TRAP
Horizontal Termination Cap
13 in.
(330 mm)
SLP-HRC-SS
SLP-HRC-ZC-SS
HORIZONTAL TERMINATION CAP
Heat & Glo • SLR32 • 2269-900 Rev. E • 4/12
Heat
Shield
Term Cap
Max
Effective
Trap1
Length
Trap2
Effective Length
5-3/4 to 8-3/8 in.
5-1/2 in.
146 to 213 mm
140 mm
3°
87°
Minimum
Maximum
Effective Length
Effective Length
3-1/8 in.
4-3/4 in.
79 mm
121 mm
5-1/4 in.
9-1/4 in.
133 mm
235 mm
8-3/8 in.
213 mm
10-1/2 in.
267 mm
10-7/8 in.
276 mm
65
Advertisement
Table of Contents
