Table of Contents
Advertisement
Installing the 8610 Chassis in a Rack with Threaded Screw Holes
NOTE:
You may want to install the three supplied #4-40 Phillips pan-head screws for the
rear Telco connectors on the rear connectors before rack mounting the DSLAM.
This will make them readily available when needed. See Installing Network Tip and
Ring Connections on page 21 for more information.
"
Procedure
To install the 8610 chassis in a rack that has threaded screw holes:
1. Install the mounting brackets on the 8610 chassis by removing the two front
screws on each side of the unit. You will reuse these screws to secure the
mounting brackets to the 8610 chassis.
— For a 19-inch rack installation,
the notched flange of the
mounting bracket is placed
against the side of the 8610
chassis.
— For a 23-inch rack installation,
the smaller flange of the
mounting bracket is placed
against the side of the 8610
chassis.
2. Secure the mounting brackets to the 8610 chassis by using the screws removed
from the sides of the unit.
3. Determine the preferred placement of the 8610 chassis in the rack. Then, mark the
appropriate locations for the mounting screws on the rack.
4. Place the 8610 chassis
against the front rails of the
rack and secure with the
appropriate mounting screws.
Repeat these steps for each
succeeding 8610 chassis.
19-Inch
Rack
Front Rail
12
23-Inch
Rack
98-15451a
D
E S
99-16314
Advertisement
Table of Contents
