Interconnecting 8610 Systems - Paradyne HOTWIRE 8610 DSLAM Installation Instructions Manual

Hide thumbs Also See for HOTWIRE 8610 DSLAM:

Table of Contents

Interconnecting 8610 Systems

Procedure

To interconnect multiple 8610 systems:

1. Connect the end of an 8-pin modular cable into the Management OUT port of the

base chassis.

2. Dress the 8-pin modular cable to the left and under the chassis, behind the foot,

and up the side of the unit.

3. Plug the other end of the 8-pin modular cable into the Management IN port of the

8610 chassis above, dressing the cable as in the previous step.

4. Repeat for the next 8610 chassis, connecting the Management OUT port of

Chassis 2 to the Management IN port of Chassis 3.

NOTE:

Bus cables must use Unshielded Twisted Pair (UTP) CAT5 cable. The total bus

cabling should not exceed 25 feet.

Table of Contents