Installing Network Tip And Ring Connections - Paradyne HOTWIRE
8610 DSLAM Installation Instructions Manual

NOTE:
If you are connecting the Hotwire 8610 DSLAM to a CO POTS splitter, this
procedure assumes that the CO POTS splitter shelf is already installed. For
information on how to install the CO POTS splitter, refer to the Hotwire POTS
Splitter Central Office Installation Instructions , Document No. 5020-A2-GN10.

Installing Network Tip and Ring Connections

"
Procedure
To connect a port card in the 8610 chassis to a POTS splitter shelf or MDF:
1. Make sure that the anchor mount is installed on the side of the connector where
the cable will lie.
2. Replace the longer #4-40 screw on the cable connector with the #4-40 Phillips
pan-head screw shipped in a plastic bag with the unit. Do not insert the screw past
the connector body until Step 5.
3. Plug the Telco 50-pin cable into the appropriate connector for the slot containing
the card (labeled 1, 2, or 3) on the rear of the 8610 chassis.
4. Thread the cable tie through the anchor mount provided. Tighten the cable tie
around the connector and cut off any excess.
5. Secure the Telco 50-pin cable by tightening the Phillips pan-head screw (that you
replaced in Step 2) on either the left or right side of the connector, depending on
the cable location.
6. Make sure the other end of the cable is connected to the appropriate POTS splitter
shelf, MDF, or demarcation point.
Anchor
Mount
NOTE:
For detailed information, refer to the Hotwire POTS Splitter Central Office
Installation Instructions .
Telco 50-Pin
Connector
21
Replaced with
Supplied #4-40
Phillips Pan-head
Screw
99-16329-01