Siemens 108 User Manual page 30

Basic Setup Wizard
If your network does not have a DHCP server yet, then you can use the DHCP server inte-
grated in your Gigaset WLAN Repeater 108 to assign the IP addresses of the connected
devices automatically.
ì
In this case, select the On option for the DHCP server.
ì
If you have activated the DHCP server integrated in your Gigaset WLAN Repeater
108, you should also check the following settings and make any changes that are
necessary.
– The First issued IP address and Last issued IP address entries define the range
of IP addresses that your Gigaset WLAN Repeater 108 should use to automatically
assign IP addresses to PCs.
– In the Default gateway field, enter the IP address of your router that is to be used
to connect your PCs to the Internet (e.g. 192.168.2.1).
Example of LAN settings with two repeaters
If you want to use several Gigaset WLAN Repeater 108 in the same network, make sure
you assign different IP addresses to each of them. Use an address block that is within the
selected subnet but not in the address block of the addresses automatically assigned by
the DHCP server in your network. Switch off both associated DHCP servers.
For two repeaters in the same network, you could, for example, assign
u
the IP address 192.168.2.210 for Gigaset WLAN Repeater 108 A,
u
the IP address 192.168.2.240 for Gigaset WLAN Repeater 108 B.
Internet
ì
Once you have completed the settings for your local network, click on Next >.
30
Gigaset WLAN Repeater 108 A
)))
)))
Gigaset WLAN Repeater 108 B
(((
)))
)))
(((
(((
(((