HP Z1 Maintenance And Service Manual page 25

Table 2-1 Computer Setup (F10) Utility menu descriptions (continued)
Heading Option
Boot Order
Security Setup Password
Power-On
Password
Description
Enables you to configure the boot orders by physically reordering the menu entries. The following
is the default boot order presented in the menu:
EFI Boot Sources
●
USB Floppy/CD
◦
USB Hard Drive
◦
ATAPI CD/DVD Drive
◦
Legacy Boot Service
●
ATAPI CD/DVD Drive
◦
USB Floppy/CD
◦
Hard Drive
◦
— USB Hard Drive
— Hard Drive Name
Network Controller (This option is only available if the workstaion is connected to a
◦
network.)
Use the arrow keys to move the cursor to the desired device, and then perform one of the
following actions:
Press Enter to select the device, then use the arrow keys to move that device up or down in
●
the boot order. Press F10 to accept the new boot order.
Press F5 on a selected device to enable or disable the device from consideration as a
●
bootable device.
Press Enter and the selected device will be de-selected.
●
MS-DOS drive lettering assignments might not apply after an operating system other than MS-DOS
has started.
Boot devices can be disabled in the boot order process. These order changes are stored in the
physical ROM when the F10 Setup changes are confirmed with
You can temporarily override the boot order. To start one time from a device other than the default
device specified in Boot Order, restart the workstation and press
message appears on the screen. After POST completes, a list of bootable devices is displayed.
Use the arrow keys to select the preferred bootable device and press
starts from the selected non-default device for this one time.
Enables you to set and enable a setup password for the administrator.
If you create a setup password, you must use it to change workstation setup options, to flash the
ROM, and to make changes to certain Plug and Play settings under Windows.
Enables you to set and enable the power-on password.
File > Save Changes
F9 when the F9=Boot Menu
Enter. The workstation then
Computer Setup (F10) Utility
and Exit.
17