HP Z1 Maintenance And Service Manual page 24

Table 2-1
Heading
Storage
16 Chapter 2 System management
Computer Setup (F10) Utility menu descriptions (continued)
Option Description
Default Setup Provides these options:
●
●
Apply Defaults Restores the default settings defined in Default Setup.
and Exit
Ignore Changes Exits workstation setup without applying or saving changes.
and Exit
Save Changes Saves changes to system configuration and exits the workstation setup.
and Exit
Device Lists installed non-SCSI storage devices (except SATA devices) and provides options for obtaining
Configuration specific information about each device:
●
●
●
●
Storage Options Provides these options:
●
●
DPS Self-text Select a drive—Lets you execute self-tests on SATA hard drives capable of performing Drive
Protection System (DPS) self-tests.
NOTE:
performing the DPS self-tests.
Save Current Settings as Default—Saves the current settings as default settings for the next
operation.
Restore Factory Settings as Default—Restores the factory settings as the default settings for the
next operation.
Hard Disk SATA0
SATA2 (Blu-Ray) — Shows the default settings Mode (BR), Firmware, Serial Number,
Connector Color)
SATA2 (DVD) — Shows the default settings Mode (DVD), Firmware, Serial Number,
Connector Color).
Default Values (SATA defaults)
Translation Mode—Enables the BIOS to determine the translation mode used to
◦
configure a formatted SATA or USB mass storage device. This prevents you from
needing to know how the mass storage device was formatted. Options are Automatic,
Bit Shift, LBA Assisted, User (Cylinders, Heads, Sectors), and Off. Automatic is the
default.
Ordinarily, you should not change the translation mode selected by the BIOS. If the
selected translation mode is not compatible with the translation mode that was active
when the drive was partitioned and formatted, the data on the disk is inaccessible.
Removable Media Boot—Enables and disables the ability to start the workstation from
removable media.
SATA Emulation—Sets the SATA emulation mode with the following options:
RAID + AHCI—Both the RAID and AHCI OPROMs execute. This emulation mode is the
◦
default and offers the best performance and most functionality.
IDE—Offers standard SATA supports (four ports only).
◦
This selection appears only when the system has one or more drives capable of