Wireless - Sitecom WL-350 Full Manual

Wireless

These options allow you to enable/disable the wireless interface, switch between
the 11n, 11b/g and 11b radio band and channel frequency.
The "Wireless Settings 1" tab contains the settings for the 2.4GHz interface, and
the "Wireless Settings 2" tab contains the settings for the 5GHz interface.
Enable Wireless: Place a check in this box to enable the wireless interface.
It is enabled by default.
Wireless Network Name (SSID): The SSID is a unique named shared
amongst all the points of the wireless network. The SSID must be identical on
all points of the wireless network and cannot exceed 32 characters.
802.11 Mode: Select the IEEE 802.11 mode from the drop-down list. For
example, if you are sure that the wireless network will be using only IEEE
802.11g clients, then it is recommended to select 802.11g only instead of
2.4 GHz B+G, which will reduce the performance of the wireless network.
You may also select Mixed 802.11n, 802.11g and 802.11b. If all of the
wireless devices you want to connect with this router can connect in the same
transmission mode, you can improve performance slightly by choosing the