Table of Contents
Advertisement
Subnet Mask: Specify the subnet mask for this IP address, which is assigned
by your ISP.
Default Gateway: Specify the IP address of the default gateway, which is
assigned by your ISP.
Primary / Secondary DNS Address: Specify the primary and secondary IP
address, which is assigned by your ISP.
MTU: The Maximum Transmission Unit (MTU) is a parameter that determines
the largest packet size (in bytes) that the router will send to the WAN. If LAN
devices send larger packets, the router will break them into smaller packets.
Ideally, you should set this to match the MTU of the connection to your ISP.
Typical values are 1500 bytes for an Ethernet connection and 1492 bytes for a
PPPoE connection. If the router's MTU is set too high, packets will be
fragmented downstream. If the router's MTU is set too low, the router will
fragment packets unnecessarily and in extreme cases may be unable to
establish some connections. In either case, network performance can suffer.
MAC Address: If you need to change the MAC address of the router's WAN-
side Ethernet interface, either type in an alternate MAC address (for example,
the MAC address of the router initially connected to the ISP) or click on Clone
Your PCs MAC Address.
Click on the Apply button to store these settings. DHCP Connection (Dynamic IP
Address)
Advertisement
Table of Contents
Need help?
Do you have a question about the WL-350 and is the answer not in the manual?
Questions and answers